Your Motorola Razr comes with a faceplate of its own, but after time you might grow a little bored with it and want to get a new one. Before attempting to change your old faceplate, make sure your new one will fit correctly. It can be a little difficult to remove the old faceplate and put on the new one the first time, but it gets easier once you've done it a few times.
Instructions
1. It is quite dangerous to keep your cell phone on during this process, so turn it off (you'll be taking out the battery anyway). Simply press and hold the red "End" button on the inside of the phone to turn your Razr off.
2. Start with the back cover. Press the small button on the back of your cell phone with a screwdriver or a ballpoint pen. This will allow the battery cover to come off. Then remove the battery; it should come right out with a little tug.
3. Unscrew the phone. With the battery compartment exposed, take out the two screws at the left and the right edge in the middle. Then wedge a credit card or a similar card into the opening between the lower half of the phone and the battery compartment. This will get the cover loose, but not all the way off. The cover is still connected to your phone's motherboard via a connector. Remove the connector with a pair or tweezers, then pull off the loose cover.
4. Use the screwdriver to unscrew the screws on the front of the phone. The front cover will then come off.
5. Apply the new covers. For the front cover, all you have to do is align the cover and screw the screws in. For the bottom you have to plug the motherboard in again and then screw on the back cover. Once all of the screws are in the cover, you can turn on your phone and start using it.
Tags: back cover, battery compartment, cell phone, front cover, loose cover, Motorola Razr, This will